LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 503 (Transfer Case - Mp 3023/3024 (NQH)) >> Diagnostic Information and Procedures >> DTC P2160 or P2161 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Key OFF. Let sit for 2 minutes to ensure that the ECM shuts down.
  2. Disconnect the X1 connector from the VSS. Using the J 35616-2A GY probes, test for less than 0.1 V between the following circuits and a good ground.
    • VSS high signal circuit, VSS harness X1 pin A.
    • VSS low signal circuit, VSS harness X1 pin B.
      • If the voltage is greater than the specified value, test the affected circuit for a short to voltage. If all circuits and connections test normal, test the ECM for proper operation.
  3. Key ON, engine OFF. Test for a diagnostic 2-3 V (low current) between the following circuits and a good ground.
    • VSS high signal circuit, VSS harness X1 pin A.
    • VSS low signal circuit, VSS harness X1 pin B.
      • If the voltage is less than the specified value, test the affected circuit for an open/high resistance, short to ground or short together. If all circuits and connections test normal, test the ECM for proper operation.
      • If the voltage is greater than the specified value, test the affected circuit for a short to voltage. If all circuits and connections test normal, test the ECM for proper operation.
  4. Test the VSS for proper operation.
scientia non olet · About LEMON Manuals