LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 502 (Transfer Case - Mp 3010 (NP0)) >> Repair Instructions - On Vehicle >> Front Output Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
    4. Fig 1: Front Output Shaft Slinger And Oil Seal
    GM2716860Courtesy of GENERAL MOTORS COMPANY
  4. Using an appropriate tool, remove the front output shaft oil slinger (2) from the transfer case.
  5. Using an appropriate tool, remove the front output shaft oil seal (1) from the transfer case.
scientia non olet · About LEMON Manuals