LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 502 (Transfer Case - Mp 3010 (NP0)) >> Repair Instructions - Off Vehicle >> Transfer Case Disassemble >> Input Shaft Oil Seal Removal

Input Shaft Oil Seal Removal

WARNING: This page is about a different car, the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Illustrating Proper Input Shaft Oil Seal Installation
GM2249581Courtesy of GENERAL MOTORS COMPANY
Input Shaft Oil Seal Removal

Callout Component Name
1 Input Shaft Oil Seal
CAUTION:

Refer to Machined Surface Damage Caution .

Procedure

  1. Drill a pilot hole, as required, and insert a self-tapping screw into the body of the seal.
  2. Use a plier or slide hammer type tool to remove the seal from the bore.
scientia non olet · About LEMON Manuals