LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Spark Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug And Sparkplug Seat
    GM14824Courtesy of GENERAL MOTORS COMPANY
  1. Correctly position the spark plug washer.
  2. Inspect the spark plug gap. Adjust the gap as needed. Refer to Ignition System Specifications
  3. Hand start the spark plug in the corresponding cylinder.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the spark plug.

    Tighten 

    Tighten the plug to 15 N.m (11 lb ft).

    5. Fig 2: View of Spark Plug Wires
    GM1707125Courtesy of GENERAL MOTORS COMPANY
  5. Install the spark plug wire to the spark plug.
  6. Inspect the spark plug wire for proper installation:
    1. Push sideways on each boot in order to inspect the seating.
    2. Reinstall any loose boot.
  7. If a right side spark plug(s) was replaced, install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
  8. If a right side spark plug(s) was replaced, perform the service reconnect. Refer to High Voltage Enabling .
scientia non olet · About LEMON Manuals