LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.

    Fig 1: View Of MAP Sensor & Retainer
    GM1697060Courtesy of GENERAL MOTORS COMPANY
  1. Install the MAP sensor.
  2. Install the MAP sensor retainer.
    3. Fig 2: View Of Engine Harness Retainer Nut & Electrical Connectors
    GM1696891Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine harness wiring electrical connector (4) to the MAP sensor (1).
  4. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals