LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Pipe & Clips
    GM1965576Courtesy of GENERAL MOTORS COMPANY
  1. Install the EVAP pipe (3) to the vehicle.
  2. Connect the EVAP pipe quick connect fitting to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Connect the EVAP pipe quick connect fitting to the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Install the EVAP pipe clip (1) to the rear brake front pipes.
  5. Install the EVAP pipe clip (2) to the frame crossmember.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals