LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Engine Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Wiring Harness Electrical Connector & ECM
    GM1960211Courtesy of GENERAL MOTORS COMPANY
  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the battery and battery tray. Refer to Battery Tray Replacement .
  4. Remove the under hood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .
  5. Disengage the engine wiring harness electrical connector retainers and remove the connectors (2) from the ECM (1).
    6. Fig 2: View Of Bracket Retainer Tabs, ECM Bracket & Tab
    GM1960213Courtesy of GENERAL MOTORS COMPANY
  6. Disengage the bracket retainer tabs (1) securing the ECM to the bracket.
  7. Remove the ECM (3) from the bracket.
scientia non olet · About LEMON Manuals