Installation Procedure
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air cleaner outlet duct (3) to the throttle body and MAF/IAT sensor. Ensure that the resonator tab aligns with the stud on the intake manifold.
- Push down on the air cleaner outlet duct resonator directly over the resonator tab in order to secure the resonator to the stud on the intake manifold.
- Tighten the air cleaner outlet duct clamp (2) at the throttle body.
- Tighten the air cleaner outlet duct clamp (1) at the MAF/IAT sensor.
Tighten
Tighten the clamps to 4 N.m (35 lb in).
- Install the radiator inlet hose clamp clip (2) to the air cleaner outlet duct (1).
- Install the PCV line (1) to the air cleaner outlet duct.
- Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
NOTE:
Ensure that the notch in the air cleaner outlet duct throttle body aligns with the boss on top of the throttle body.
CAUTION:
Refer to Fastener Caution .