Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Column Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Align and fasten the nuts that hold the knee bolster deflector.
Tighten: Tighten the nuts to 2 N.m (18 lb in).
Fasten the screws/bolts that hold the knee bolster trim panel to the I/P. Refer to Driver Knee Bolster Panel Replacement .
Align and move forward center console in place and fasten to the center console bracket. Refer to Console Replacement .