Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Connect the electrical connectors.

Fig 1: Using Hot Melt Glue Gun To Align Console To Headliner Holes

Courtesy of GENERAL MOTORS CORP.

Using a hot melt glue gun, run a bead of glue on tabs and align the console to the headliner holes.

Fig 2: Fastening Overhead Console To Headliner

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the console roof screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Check for console operation.