Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Upper Trim Pad

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the upper trim pad to the I/P.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the right trim panel accessory to the I/P.
Tighten: Tighten the screws to 2 N.m(18 lb in).
Install the center trim panel to the I/P compartment. Refer to Instrument Panel Center Trim Panel Replacement .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the left trim plate to the I/P. Refer to Instrument Panel Accessory Trim Plate Replacement - Left Side .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the right trim plate to the I/P. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the knee bolster to the I/P compartment. Refer to Driver Knee Bolster Panel Replacement .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the I/P compartment door. Refer to Instrument Panel Compartment Replacement .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the trim panel to the I/P cluster. Refer to Instrument Cluster Trim Panel Replacement .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the door striker to the I/P compartment. Refer to Instrument Panel Compartment Door Lock Striker Replacement .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the assist handle to the I/P. Refer to Instrument Panel Assist Handle Replacement .
Tighten all parts of the center console. Refer to Console Replacement .