LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Instrument Panel And Console Trim) >> Repair Instructions >> Instrument Panel Compartment Door Latch Release Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new handle assembly to compartment door.
  2. Ensure the linkage for the top compartment door are all connected before installing the inside panel.
    3. NOTE: Refer to Fastener Notice .
  3. Install the inside panel screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  4. Inspect the operation of the top compartment door
    5. Fig 1: I/P Compartment Door Hinge
    GM816341Courtesy of GENERAL MOTORS CORP.
  5. Install the compartment door to the I/P. Refer to Instrument Panel Compartment Door Replacement .
scientia non olet · About LEMON Manuals