Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: I/P Carrier Center Support Bracket Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Align the center bracket with the I/P and floor, then bolt the bracket in place.
Tighten: Tighten the bolt to 25 N.m (18 lb in).
Install the extension panel the I/P. Refer to Instrument Panel Extension Trim Plate Replacement .
Install the center console to the center console bracket. Refer to Console Replacement .