LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Instrument Panel And Console Trim) >> Repair Instructions >> Instrument Panel Assist Handle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: I/P Passenger Side Trim Panel
    GM1373239Courtesy of GENERAL MOTORS CORP.
  1. Remove the passenger I/P (Instrument Panel) side trim panel.
  2. Fully open the I/P storage compartment.
    3. IMPORTANT: Both the left and the right assist handle release buttons face the outside of the vehicle. The release buttons need to be pushed towards the inside of the vehicle to release the assist handle.
  3. Using a long flat-bladed tool, through the opening in the I/P retainer (1) on the passenger side of the I/P:
    1. Push in on the assist handle release button (2) and
    2. Pull out on the handle to partially disengage the assist handle.
  4. Using a flat-bladed tool, through the I/P storage compartment opening, push in on the inboard assist handle release button (3).
  5. Remove the I/P assist handle.
scientia non olet · About LEMON Manuals