Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: I/P Accessory Right Trim Panel

Courtesy of GENERAL MOTORS CORP.

Align the trim pad with the I/P substrate tabs.

NOTE: Refer to Fastener Notice .

Install the trim panel screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
Install the I/P assist handle. Refer to Instrument Panel Assist Handle Replacement .