LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Instrument Panel And Console Trim) >> Repair Instructions >> Front Floor Console Compartment Door Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the latch by pressing inwards until it is seated.
    2. NOTE: Refer to Fastener Notice .
  2. Install the latch screws.

    Tighten:  Tighten the latch screws to 1.6 N.m (14 lb in).

  3. Install the inside panel.
    4. Fig 1: Console Compartment Center Door Latch
    GM838962Courtesy of GENERAL MOTORS CORP.
  4. Install the console door inner screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    5. Fig 2: Compartment Door & Console
    GM838971Courtesy of GENERAL MOTORS CORP.
  5. Inspect the top compartment door operation.
  6. Install the compartment door to the console. Refer to Front Floor Console Compartment Door Replacement .
scientia non olet · About LEMON Manuals