LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Instrument Panel And Console Trim) >> Repair Instructions >> Driver Knee Bolster Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Knee Bolster Trim Panel
    GM832830Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the knee bolster trim panel to I/P.
  2. Install the knee bolster trim panel screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Install the IPC trim. SeeInstrument Cluster Trim Panel Replacement .
  4. Align and move forward center console in place and fasten to center console bracket. Refer to Console Replacement .
scientia non olet · About LEMON Manuals