Installation Procedures

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cup Holder

Courtesy of GENERAL MOTORS CORP.

Connect the lamps to the bezel.
Align the bezel to the center console.
Push the bezel firmly into place to engage the clips.

Fig 2: Identifying Shifter

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install shift handle to shifter and use hex nut to fasten in place.
Tighten: Tighten the nut to 1.6 N.m (14 lb in).