LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Instrument Panel And Console Trim) >> Repair Instructions >> Center Console End Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connectors & Center Console End Panel
    GM832798Courtesy of GENERAL MOTORS CORP.
  1. Connect electrical connectors to console end panel.
    2. NOTE: Refer to Fastener Notice .
    Fig 2: Center Console End Panel
    GM816358Courtesy of GENERAL MOTORS CORP.
  2. Install the center console end panel.
  3. Install the center console end panel screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

scientia non olet · About LEMON Manuals