LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Electronic Suspension Rear Position Sensor Link Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Link Rods To Ball Studs Using J 38185
    GM613614Courtesy of GENERAL MOTORS COMPANY
  1. Using the J 38185  hose clamp pliers, install to link rod to the ball stud on the sensor lever and the frame bracket.
  2. Install the ESC sensor to the vehicle. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side , or Electronic Suspension Rear Position Sensor Replacement - Right Side .
scientia non olet · About LEMON Manuals