Installation Procedure
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the auxiliary fluid pump gasket (3).
- Install the auxiliary fluid pump (2).
- Install the auxiliary fluid pump bolts (1).
Tighten
Tighten the bolts to 9-13 N.m (80-115 lb in).
- Install the auxiliary fluid pump wire harness clip nut (3).
Tighten
Tighten the nuts to 9 N.m (80 lb in).
- Lower the vehicle.
- Install the auxiliary fluid pump wire harness (6) to the harness retainers (7).
- Connect the auxiliary fluid pump wire harness (1) to the auxiliary fluid pump control module connector (2).
- Fill the transmission with the proper amount of transmission fluid. Refer to Fluid Capacity Specifications , and Transmission Fluid Level and Condition Check .
CAUTION:
The auxiliary fluid pump gasket is not re-usable. Use a NEW gasket when replacing or damage may occur.
CAUTION:
Do not damage the case sealing surface when removing or installing the pump and motor assembly.
CAUTION:
Refer to Fastener Caution .
Fig 2: Auxiliary Fluid Pump Wire Harness, Control Module Connector, Wire Harness, Retainers & Clip Nut
CAUTION:
Use Dexron VI transmission fluid only. Failure to use the proper fluid may result in transmission internal damage.