Installation Procedure
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the auxiliary fluid pump control module (2) to the engine control module bracket.
- Install the auxiliary fluid pump control module electrical connector (1) to the auxiliary fuse block.
- Connect the auxiliary fluid pump control module electrical connector (1) to the engine wiring harness electrical connector (2).
- Connect the auxiliary fluid pump electrical wire harness connector (1) to the auxiliary fluid pump control module connector (2).
Fig 2: Auxiliary Fluid Pump Control Module Electrical Connector & Engine Wiring Harness Electrical Connector
Fig 3: Auxiliary Fluid Pump Wire Harness, Control Module Connector, Wire Harness, Retainers & Clip Nut