Installation Procedure
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the range selector lever (2).
- Install the range selector lever nut (1) and tighten to 25 N.m (18 lb ft).
- Install the range selector lever cable (2) to the cable bracket.
- Install the range selector lever cable retainer (1).
- Connect the range selector lever cable (2) to the range select lever.
- Install the range selector lever cable heat shield (2).
- Install the range selector lever cable heat shield bolts (1) and tighten to 17 N.m (13 lb ft).
- Lower the vehicle.
WARNING:
Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.
CAUTION:
Refer to Fastener Caution .