Temperature Valve Actuator Replacement - Right Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Temperature Valve Actuator Replacement - Right Side

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
CAUTION: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module. Preliminary Procedures Remove the inflatable restraint instrument panel module. Refer to Instrument Panel Inflatable Restraint Module Replacement . Disconnect the electrical connector from the air temperature actuator.
1	Air Temperature Actuator Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 1.6 N.m (14 lb in)
2	Air Temperature Actuator Procedure Re-calibrate the air temperature actuator. Refer to Actuator Recalibration . NOTE: Apply Dielectric Nyogel 760G grease to the electrical connector. Dispense grease on the connector to cover all holes in the connector.

Callout

Component Name

CAUTION:

In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.

Preliminary Procedures

Remove the inflatable restraint instrument panel module. Refer to Instrument Panel Inflatable Restraint Module Replacement .
Disconnect the electrical connector from the air temperature actuator.

Air Temperature Actuator Screw (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
1.6 N.m (14 lb in)

Air Temperature Actuator
Procedure
Re-calibrate the air temperature actuator. Refer to Actuator Recalibration .

NOTE:

Apply Dielectric Nyogel 760G grease to the electrical connector. Dispense grease on the connector to cover all holes in the connector.