LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 493 (HVAC System - Automatic) >> Repair Instructions >> Auxiliary Inside Air Temperature Sensor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the third pillar molding. Refer to Center Pillar Upper Garnish Molding Replacement .
  2. Remove the left rear coat hook, if equipped. Refer to Coat Hook Replacement .
  3. Remove the rear headliner retainers from the front headliner.
  4. Carefully lower the headliner from the roof hook and loop retainers.
    5. Fig 1: View of Air Temperature Sensor Electrical Connector
    GM675996Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the electrical connector from the inside air temperature sensor.
    6. Fig 2: Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS COMPANY
  6. Partially remove the auxiliary inside air temperature sensor from the headliner.
  7. Remove the sensor grille from the auxiliary inside air temperature sensor.
  8. Remove the auxiliary inside air temperature sensor from the headliner.
scientia non olet · About LEMON Manuals