Power Seat Inoperative (Passenger)
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Power Seat Inoperative (Passenger)
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Passenger Seat Schematics Connector End View Reference: Power Seat Connector End Views DEFINITION: All of the seat adjuster motors are inoperative, the lumbar and bolster motors may also be inoperative. |
|||
| 1 | Did you review the Power Seats System Description and Operation? | Go to Step 2 | Go to |
| 2 | Verify the fault is present. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Connect a test lamp from the battery voltage supply circuit terminal to the ground circuit terminal in the seat adjuster switch harness connector. Does the test lamp illuminate? |
Go to Step 7 | Go to Step 6 |
| 5 | Repair the battery voltage supply circuit for an open or short to ground. Refer to Wiring Repairs
. Is the repair complete? |
Go to Step 9 | - |
| 6 | Repair the ground circuit for an open or high resistance. Refer to Wiring Repairs
. Is the repair complete? |
Go to Step 9 | - |
| 7 | Inspect for poor connections at the seat adjuster switch harness connector. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 8 | Replace the seat adjuster switch. Refer to Seat Switch Replacement - Power . Is the repair complete? |
Go to Step 9 | - |
| 9 | Operate the system to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |