LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Valve Rocker Arm and Push Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

When reusing the valve train components, always install the components to the original location and position.

Valve lash is net build, no valve adjustment is required.

    Fig 1: View Of Valve Rocker Arm Pivot Support
    GM260141Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the rocker arms and pushrods with clean engine oil.
  2. Lubricate the flange of the rocker arm bolts with clean engine oil. Lubricate the flange or washer surface of the bolt that will contact the rocker arm.
  3. Install the rocker arm pivot support.
    4. Fig 2: View Of Pushrods
    GM260142Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Make sure that the pushrods seat properly to the valve lifter sockets.

  4. Install the pushrods.
    5. Fig 3: View Of Rocker Arms & Bolts
    GM260140Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Make sure that the pushrods seat properly to the ends of the rocker arms. DO NOT tighten the rocker arm bolts at this time.

  5. Install the rocker arms and bolts.
    6. NOTE:

    The engine firing order is 1, 8, 7, 2, 6, 5, 4, 3. Cylinders 1, 3, 5 and 7 are the left bank. Cylinders 2, 4, 6 and 8 are the right bank.

  6. Rotate the crankshaft until the number one piston is at top dead center (TDC) of the compression stroke. In this position, the number one cylinder rocker arms will be off lobe lift.
    7. CAUTION:

    Refer to Fastener Caution .

  7. With the engine in the number one firing position, tighten the following rocker arm bolts:

    Tighten 

    • Tighten cylinders 1, 2, 7 and 8 exhaust valve rocker arm bolts to 30 N.m (22 lb ft).
    • Tighten cylinders 1, 3, 4 and 5 intake valve rocker arm bolts to 30 N.m (22 lb ft).
  8. Rotate the crankshaft 360 degrees.
  9. Tighten the following rocker arm bolts:

    Tighten 

    • Tighten cylinders 3, 4, 5 and 6 exhaust valve rocker arm bolts to 30 N.m (22 lb ft).
    • Tighten cylinders 2, 6, 7 and 8 intake valve rocker arm bolts to 30 N.m (22 lb ft).
  10. Install the number one cylinder spark plug. Refer to Spark Plug Replacement .
  11. Install the rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left Side , or Valve Rocker Arm Cover Replacement - Right Side .
scientia non olet · About LEMON Manuals