LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Pump, Screen, and Crankshaft Oil Deflector Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Screen & O-Ring Seal
    GM647800Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil pan. Refer to Oil Pan Replacement (4WD) , Oil Pan Replacement (2WD) .
  2. Remove the engine front cover. Refer to Engine Front Cover Replacement .
  3. Remove the oil pump screen bolt and nuts.
  4. Remove the oil pump screen with O-ring seal.
  5. Remove the O-ring seal from the pump screen.
  6. Discard the O-ring seal.
    7. Fig 2: View Of Crankshaft Oil Deflector & Nuts
    GM683798Courtesy of GENERAL MOTORS COMPANY
  7. Remove the remaining crankshaft oil deflector nuts.
  8. Remove the crankshaft oil deflector.
    9. Fig 3: View Of Oil Pump & Bolts
    GM1658170Courtesy of GENERAL MOTORS COMPANY
  9. Remove the oil pump bolts (411).
    10. NOTE:

    Do not allow dirt or debris to enter the oil pump assembly, cap end as necessary.

  10. Remove the oil pump (413).
scientia non olet · About LEMON Manuals