LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side (except L96) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM1701802Courtesy of GENERAL MOTORS COMPANY
  1. Position the engine mount to the engine block.
    2. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701799Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Working through the wheelhouse opening, install the engine mount to engine block bolts (1) and tighten to 50 (37 lb ft).
  3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  4. Remove the adjustable jack and block of wood from the engine oil pan.
    5. Fig 3: View Of Engine Mount To Frame Bolts
    GM1701796Courtesy of GENERAL MOTORS COMPANY
  5. Clean the threads of the engine mount to engine mount bracket bolts using denatured alcohol or equivalent.
  6. Apply threadlocker or equivalent to the threads of the engine mount to engine mount bracket bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  7. Install the engine mount to engine mount bracket bolts and tighten to 65 N.m (48 lb ft).
  8. Install the starter. Refer to Starter Replacement
  9. Install exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Right Side .
  10. If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement .
  11. Install the battery cable attachment on the frame.
  12. Install the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
  13. Lower the vehicle.
  14. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  15. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals