LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Bracket Replacement - Left Side (L96) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.

    Fig 1: View Of Engine Mount Bracket Bolts
    GM1701018Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the left wheel house liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
  5. Remove the engine mount to engine mount bracket bolts (1).
  6. Position an adjustable jack and a block of wood under the engine oil pan.
  7. Raise the engine slightly.
    8. Fig 2: View Of Engine Mount Bracket & Bolts
    GM1701674Courtesy of GENERAL MOTORS COMPANY
  8. Remove the engine mount bracket through bolts.
  9. Remove the engine mount bracket.
scientia non olet · About LEMON Manuals