LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Block Valley Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Engine Valley Cover
    GM1403316Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intake manifold. Refer to Intake Manifold Replacement (RPOs LC9, LMG, LY5, L76) , Intake Manifold Replacement (RPOs LY2, LY6) , Intake Manifold Replacement (Except RPOs LY2, LY6, LC9, LMG, LY5) .
  2. Remove the engine valley cover bolts (506).
  3. Remove the engine valley cover (555) and gasket (556).
  4. Remove the O-ring seals (537) from the cover.
    5. Fig 2: Removing/Installing Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS COMPANY
  5. Remove the oil pressure sensor (706) and washer (707).
scientia non olet · About LEMON Manuals