LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Rear Oil Seal & Housing
    GM1552461Courtesy of GENERAL MOTORS COMPANY
  1. If equipped with an automatic transmission, remove the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement .
  2. If equipped with a manual transmission, remove the flywheel. Refer to the appropriate article .
  3. Remove and discard the crankshaft rear oil seal (141).
scientia non olet · About LEMON Manuals