LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pan-To-Rear Cover Bolts
    GM680413Courtesy of GENERAL MOTORS COMPANY
  1. If equipped with an automatic transmission, remove the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement .
  2. If equipped with a manual transmission, remove the flywheel. Refer to appropriate article. .
  3. Remove the oil pan-to-rear oil seal housing bolts (1).
    4. Fig 2: Identifying Rear Oil Seal Housing Components
    GM2100849Courtesy of GENERAL MOTORS COMPANY
  4. Remove the rear oil seal housing bolts (1).
  5. Remove the rear oil seal housing (2) and gasket (3). Discard the gasket.
  6. Remove and discard the rear oil seal (4).
scientia non olet · About LEMON Manuals