LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Installation Procedure - Cover with Seal

Installation Procedure - Cover with Seal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the J-41479-2A  guide cone and bolts onto the rear of the crankshaft.
    2. Fig 1: Identifying Rear Housing Components
    GM2100848Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW rear housing gasket (1), rear housing with seal (2), rear housing-to-engine bolts (3) and oil pan-to-rear housing bolts (4).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Tighten the rear housing-to-engine bolts (3) until snug. Do not overtighten.
  4. Tighten the oil pan-to-rear housing bolts (4) to 12 N.m (106 lb in).
  5. Tighten the rear housing-to-engine bolts (3) to 30 N.m (22 lb ft).
  6. Remove the J-41479-2A  guide.
  7. If equipped with a manual transmission, install the flywheel. Refer to the appropriate article. .
  8. If equipped with an automatic transmission, install the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement .
scientia non olet · About LEMON Manuals