LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Magnet Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Actuator Magnet, Bolts, Gasket & Oil Seal
    GM1658168Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The gasket surface should be free of oil or other foreign material during assembly.

  1. Install a NEW CMP actuator magnet gasket (753) onto the CMP actuator magnet.
  2. Install the CMP actuator magnet (752) to the front cover.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the CMP actuator magnet bolts (751) and tighten to 12 N.m (106 lb in).
  4. Connect the engine harness electrical connector to the CMP actuator magnet.
  5. Install the water pump. Refer to Water Pump Replacement .
scientia non olet · About LEMON Manuals