Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel drive shaft in the steering knuckle.
- Install the NEW nut (1) and washer (2).
- Install the retaining bolts and finger tighten.
- Insert a drift or large screwdriver through the brake caliper into one of the brake rotor vanes in order to prevent the wheel drive shaft from turning.
- Tighten the wheel driver shaft retaining bolts and tighten to 79 N.m (58 lb ft).
- Tighten the wheel drive shaft retaining nut and tighten to 240 N.m (177 lb ft).
- Install the shock module. Refer to Shock Absorber and Spring Removal and Installation .
- Install the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Replacement (2500) , Stabilizer Shaft Replacement (1500) .
- Install the front axle hub cap to the wheel bearing, if equipped.
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
NOTE:
Install the NEW nut and washer, but DO NOT tighten at this time.
CAUTION:
Refer to Fastener Caution .