Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Apply LOCTITE® 262, or equivalent, to the steering gear inner tie rod threads.
- Attach the steering linkage inner tie rod onto the steering gear rack.
- Place a pipe wrench on the flats on the steering gear rack (1) next to the steering linkage inner tie rod (2).
- Tighten the steering linkage inner tie rod (2).
Tighten
Tighten the steering linkage inner tie rod to 150 N.m (111 lb ft).
- Install the steering gear boot. Refer to Steering Gear Boot Replacement (Without HP2) , Steering Gear Boot Replacement (HP2) .
NOTE:
All threads must be clean prior to LOCTITE® application. Check the LOCTITE®, or equivalent, container for the expiration date. Use only enough LOCTITE® to evenly coat the threads.
CAUTION:
Refer to Fastener Caution .