LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assembly and Seals Replacement - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (Recirculating Ball Without LMM) , Steering Gear Replacement (HP2) , Steering Gear Replacement (Hydraulic Rack and Pinion) .
    2. Fig 1: View Of Cylinder Line Retaining Plate & Bolt
    GM1751420Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Protect the steering gear boots from sharp tools and from the sharp edges of surrounding components.

  2. Remove the power steering gear inlet hose retaining plate bolt (1) and the power steering gear inlet hose retaining plate (2).
    3. Fig 2: Steering Gear Cylinder Pipes & Fittings
    GM1989785Courtesy of GENERAL MOTORS COMPANY
  3. Loosen both steering gear cylinder pipe fittings (3) on the steering gear (4).
  4. Remove both steering gear cylinder pipes (2) from the steering gear (4).
  5. Remove and discard the steering gear cylinder pipe seals (1) from the steering gear (4).
scientia non olet · About LEMON Manuals