LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L) .
  2. Remove as much power steering fluid from the power steering fluid reservoir as possible.
  3. Disconnect the steering shaft coupling from the steering gear. Refer to Steering Shaft Coupling Replacement .
  4. Remove the engine shield. Refer to Engine Shield Replacement .
  5. Place drain pans under the vehicle as needed.
  6. Fig 1: View Of Power Steering Pressure Hose & Power Steering Pump
    GM898604Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the power steering gear inlet hose (2) from the power steering pump assembly from underneath the vehicle.
  8. Fig 2: View Of Power Steering Return Hoses, Clamps & Power Steering Pump
    GM898607Courtesy of GENERAL MOTORS COMPANY
  9. Disconnect the power steering fluid cooler hose clamp (5) and the power steering fluid cooler hose (4) from the power steering pump assembly (1).
  10. If equipped with hydroboost, disconnect the power brake booster outlet hose clamp (3) and disconnect the power brake booster outlet hose (2) from power steering pump assembly (1).
  11. Fig 3: View Of Power Steering Pump
    GM346660Courtesy of GENERAL MOTORS COMPANY
  12. Remove the power steering pump bracket bolt from the side of the engine.
  13. Remove the power steering pump bolts.
  14. Remove the power steering pump assembly from the vehicle.
  15. Transfer any parts as needed.