LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Pulley Installer
    GM643361Courtesy of GENERAL MOTORS COMPANY
  1. Place the power steering pump pulley on the end of the power steering pump shaft.
  2. Install the power steering pump pulley using J 25033-C  pulley installer.
    3. Fig 2: Checking Power Steering Pump Pulley Installed Depth
    GM245012Courtesy of GENERAL MOTORS COMPANY
  3. Ensure that the power steering pump pulley (1) is flush against the power steering pump shaft (2) with an allowable variance of 0.25 mm (0.010 in).
  4. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  5. Install the engine coolant fan upper shroud, if equipped. Refer to Engine Coolant Fan Upper Shroud Replacement (Mechanical) .
scientia non olet · About LEMON Manuals