LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Power Steering System) >> Repair Instructions >> Power Steering Gear Outlet Pipe/Hose Replacement (Gas With Hydroboost) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Gear Outlet Pipe/Hose & Components (With Hydroboost)
    GM1751501Courtesy of GENERAL MOTORS COMPANY
  1. Install the power steering gear outlet pipe (1) to the steering gear (2).
  2. Connect the power steering fluid cooler hose (3) and hose clamp to the steering gear (2).
  3. Clean any excess fluid from the vehicle and remove the drain pans.
  4. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals