LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (Gas With Hydroboost) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install drain pans under the vehicle as needed.
    2. Fig 1: View Of Power Brake Booster & Power Steering Gear Inlet Hose
    GM1861488Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Power Steering Hose Disconnected Caution .

    NOTE:

    Note the routing of the power steering gear inlet hose before removal. It MUST be routed correctly upon installation.

  2. Remove the power steering gear inlet hose (2) from the power brake booster (1).
  3. Remove the power steering gear inlet hose (2) from the power steering gear.
  4. Remove the power steering gear inlet hose (2) from the vehicle.
scientia non olet · About LEMON Manuals