LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement (1500) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Knuckle (1500)
    GM1869837Courtesy of GENERAL MOTORS COMPANY
  1. Install the lower ball joint in the knuckle. Refer to Lower Control Arm Replacement (1500) , Lower Control Arm Replacement (2500) .
  2. Install upper ball joint in the knuckle. Refer to Upper Control Arm Replacement (1500) , Upper Control Arm Replacement (2500) .
  3. Connect the outer tie rod to the knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
  4. Install the wheel bearing and hub assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement (1500) , Front Wheel Hub, Bearing, and Seal Replacement (2500) .
  5. Install the wheel drive shaft, if equipped. Refer to Wheel Drive Shaft Replacement (2500) , Wheel Drive Shaft Replacement (1500) .
  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Remove the support and lower the vehicle.
  8. Verify the wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals