LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (2500)

Stabilizer Shaft Insulator Replacement (2500)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Stabilizer Shaft Insulator (2500, 3500)
GM1865485Courtesy of GENERAL MOTORS COMPANY
Stabilizer Shaft Insulator Replacement (2500)

Callout Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
1 Stabilizer Shaft Clamp Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
50 N.m (37 lb ft)
2 Stabilizer Shaft Clamp
3 Stabilizer Shaft Insulator
TIP:  Ensure that the slit in the insulator is facing the front of the vehicle when installed.
scientia non olet · About LEMON Manuals