Shock Absorber Replacement (2500 Series)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Shock Absorber Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Shock Absorber Retaining Nut CAUTION: Refer to Fastener Caution . TIP: Support the lower control arm with a safety stand. Tighten 24 N.m (17 lb ft)
2	Insulator (Qty: 2) Install the lower insulator, which is smaller than the upper insulator and plastic pilot ring. Install the upper insulator, which is the larger of the 2 insulators.
3	Retaining Nut Tighten 80 N.m (59 lb ft)
4	Mounting Bolt
5	Shock Absorber TIP: If replacing the shock absorber, refer Shock Absorber Disposal for the proper disposal procedure.