LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Front Suspension System) >> Repair Instructions >> Jounce Bumper Replacement (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    The following service procedure is for 2500 series vehicles.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View Of Jounce Bumper Stud & Nut
    GM348561Courtesy of GENERAL MOTORS COMPANY
  3. Remove the nut from the jounce bumper stud.
  4. Remove the jounce bumper.
scientia non olet · About LEMON Manuals