LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Hose Removed Clip Attached To Frame
    GM788624Courtesy of GENERAL MOTORS COMPANY
  1. Install the vent hose to the clip on the frame.
    2. Fig 2: Vent Hose Removed From Rear Axle
    GM788622Courtesy of GENERAL MOTORS COMPANY
  2. Install the vent hose on the rear axle vent hose connector.
  3. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals