LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Axle Cover Bolts, Cover And Gasket
    GM1959512Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the rear axle. Refer to Differential Oil Replacement (8.6 Inch Axle) , Differential Oil Replacement (10.5 Inch Axle) , Differential Oil Replacement (9.5LD Inch Axle) .
    3. NOTE:

    Discard the axle housing cover bolts. Use NEW only.

  3. Remove the rear axle cover bolts (1), cover (2), and the gasket (3).
  4. Remove any gasket material from the rear axle housing and/or axle housing cover.
scientia non olet · About LEMON Manuals