LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Axle Cover Bolts, Cover And Gasket
    GM1959512Courtesy of GENERAL MOTORS COMPANY
  1. Position the axle housing cover (2) and the gasket (3) on the rear axle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the NEW axle housing cover bolts (1) and tighten to 40 N.m (30 lb ft).
  3. Fill the rear drive axle with the proper fluid. Refer to Differential Oil Replacement (8.6 Inch Axle) , Differential Oil Replacement (10.5 Inch Axle) , Differential Oil Replacement (9.5LD Inch Axle) .
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals