LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Drive Pinion and Ring Gear Replacement (10.5 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the differential case assembly. Refer to Differential Replacement (10.5 Inch Axle) , Differential Replacement (8.6, 9.5/9.5 LD Inch Axles) .
  3. Remove the drive pinion housing assembly. Refer to Drive Pinion Housing and/or Seal Replacement .
    4. Fig 1: Identifying Ring Gear Bolts
    GM866503Courtesy of GENERAL MOTORS COMPANY
  4. Remove and discard the gear bolts. Replace with NEW only.
    5. Fig 2: Removing Ring Gear From Differential
    GM866502Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Ring Gear Removal Caution .

  5. Using a brass drift and a hammer, remove the ring gear from the differential case.
scientia non olet · About LEMON Manuals